Flat roofing systems are more appealing to most homeowners because the roof doesn’t cut into the interior space. Flat roofs are horizontal, or very near it. They have very little slope when compared to roofs on a home or residential building, it is common for the upstairs bathroom or bedroom to be tucked under the sloped ceiling eaves. If you have a pitched roof this will have some limits since the sloped ceiling can minimize the amount of space for tall furniture. Whereas with flat roofing, you have a lot more space underneath your roof.
Many urban areas use the extra space to have a garden on the rooftop. A industrial building owner can be able to install a cooling or heating system on their rooftop.
With pitched roofing, homeowners can have the freedom to add a loft or a finished attic to the living room. Although you may think that flat roofs are completely flat, they actually aren’t. They are installed in a sloping angle to prevent water from collecting on the rooftop. Pitched roofs on the other hand have sharper slopes that effectively divert and drain water from the building. Flat roofs may seem nontraditional, but they’re prominent on homes in the Southern California, throughout Los Angeles and Orange county, Inland Empire. The drier weather of these regions means architects don’t need to worry as much about water stagnating and causing roof damage. However, flat roofs are known to leak more often because water doesn’t roll off the way it does on pitched roofs this why it is important to do the proper waterproofing to avoid roof damage, the best method to waterproof a flat roof would be to hot mop it. If the roof is not properly waterproofed water just pools until it evaporates. When this happens, it gives the water longer to find weaknesses in the roof’s surface.
If you have an older home, or if you notice signs that you have a leak, it may be time for a flat roof replacement or repair, often the dry rot can be torn out, but you have to make sure whatever you replace is waterproofed—and here are your options and what they’ll cost you.
Pitched roofs have an advantage over flat roofs because of their resistance to water leakages. Pitched roofing installation should be considered in areas that receive heavy rainfall. Competent roofing systems installation contractor will ensure they have installed a good drainage system for you that will divert water out on your roof and away from your building. Note that even if a qualified roofing system installer installs a flat roof for you, it will still be susceptible to damages caused by water in comparison to the pitched roofing system. This is because pitched roof systems make use of drainage and gravity system to collect and drain water.
Do you want to invest more, or pay more for your roofing system in the long run? You should ask yourself this question. Flat roofing installations are cheaper compared to pitched roofing systems. But pitched roofing subsequent repairs are cheaper in comparison to their counterparts.
On the hand, you find that if there is a problem with a pitched roofing system, a roofing contractor can be in a position to inspect your roof from the ground to determine if it needs any repairs. Don’t forget that flat roofs are vulnerable to leaks and need frequent repairs than pitched roofs. In addition, a competent roofing contractor can be able to provide you with accurate costs estimations for both roofing repairs and installations. The above are the main difference between flat and pitched roof in consideration of various elements they have. It is advisable to hire a licensed roofing contractor to work with during your roof installation project. A flat roof hot mop expert will be in a position to give you advice and recommendation on the best roof to put in your home or commercial building.